Welding Work To Be Done

This is what needs to be done. This is the front gas tank mount.

This is a rear fender strut nut. There are 2 of these. If the nylong insert melts no big deal.

This is the rear fender support. Welded to frame not fender.

This is the rear caliper anchor. It mounts inside the leg I am holding it against. Not outside.

These are the tabs for the oil tank. I will cut them down to the right length after welding.

This is the lower oil tank tab position.

And of course the upper oil tank mount location.

And this is the rear gas tank mount.

And finally this is the rear axle adjuster. There are 2, one on each side.